Información del modelo
Descripción
This model is a remix of the Satsana duct designed specifically for an Ender 5 equipped with a Micro Swiss direct drive and a CR Touch ABL sensor. The design positions the ducts 1.5mm from the print surface to facilitate cooling. The CR Touch mount utilizes an x offset of -47 and a y offset of -9.5. 1. Purpose: To provide a customized cooling duct solution for specific Ender 5 hardware configurations. 2. Practical uses: Cooling optimization for Ender 5 printers using Micro Swiss direct drive and CR Touch sensors. 3. Included parts: ms-cr_satsana_duct.stl, ms-cr_cable_cap.stl, and ms-cr_satsana.step.
Texto original del autor en Printables
<p>This is yet another remix of the Satsana duct. </p><p>This one is designed for an Ender 5 with the Micro Swiss direct drive and a CR Touch ABL sensor. I designed it so the ducts sit 1.5mm from the surface of the print for optimal cooling. The CR Touch mount is at the optimal height, with an x offset of -47 and y offset of -9.5.</p><p>Printing recommendations are the same as the original Satsana duct.</p><p> </p>
Preguntas y aportaciones