Model information
Description
Rims for Robak or HSP88005
Purpose
This model provides four different rim designs intended for use with the Robak or HSP88005. The author notes that while the rims have been printed, they have not been fully tested.
Practical Uses
These rims are designed for RC car applications. The author suggests that while they were printed using PETG, a hard TPU material will likely provide longer durability.
Included Parts
- Rim_V1.stl
- Rim_V2.stl
- Rim_V3.stl
- Rim_V4.stl
Printing and Assembly Guidance
To prevent supports from entering the hex socket, the middle hole is covered with a 0.2mm layer during printing. After printing, use a knife to cut the hole open.
Recommended print settings include:
- Orientation: Lay flat on the bed with the outer design facing up.
- Layer Height: 0.2mm
- Walls: 5
- Infill: 40%
- Supports: On (Caution: Do not allow supports to cover the inside of the hex socket).
Attribution: Source provided by author.
Original text by the author on Printables
<p>The hole in the middle was covered with a 0.2mm layer to prevent supports in the hex socket. After printing use a knife and cut the hole open.</p><p>Printed out of PETG but a hard TPU lasts probably longer.</p><p><strong>Print settings:</strong></p><p>5 Walls</p><p>40% infill</p><p>0.2mm Layerheight</p><p>Supports on <i>(don't cover the inside of the hex socket with supports!)</i></p><p><strong>Orientation:</strong></p><p>laying flat on the bed with the outer design looking up.</p>
Questions and contributions