Two-piece printed assembly for a single shock rear suspension modification on the Sakura D5. The source documentation identifies the assembly and lists the mounting hardware; it does not demonstrate improved grip, progressivity, or strength compared to the original suspension. The download does not include the shock, the chassis, or the hardware.

Preparation, compatibility, and printing

The source requires a 6 × 10 × 3 mm bearing, two M3 14 mm screws, M3 nuts, and washers. Verify the diagram and the position of each part with your version of the chassis. Before running, check for a smooth travel without hard points, pivot play, and the absence of rubbing. No validated print profile is documented: old generic values for infill, clearance, or material should not be interpreted as author settings. The cover is a contextual illustration, not a physical assembly test.