TPU filament tethers designed to prevent the loss of body clips during RC vehicle rollovers. To use, create a small hole in the RC body and insert the tether. The author recommends making the hole a couple of sizes smaller than the nub that goes through the body to ensure a tight fit and prevent it from pulling out.
Original text by the author on Printables
<p>I grew tired of losing body clips after a roll over and I knew these tethers already existed, but I didn't know where to buy them. Therefore, I made my own using TPU filament. Simply make a small hole in the body of the RC that you want to use the tether on and just pop the tether in that hole. Be sure to make the hole a couple sizes smaller than the nub that goes through the body to ensure a tight fit and so it doesn't pull out of the body. I've made several sets for my RC's that don't already have them and they work great. Enjoy the model.</p>
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.
The publishing account has not yet confirmed any print settings. Material, supports, difficulty, temperatures and times remain as "Not verified" until verifiable data is available.
Conversation and organization
Save it with context.
Collections are used to organize projects; comments, to ask or provide information without converting it into an evaluation.
There are no comments yet. Verified ratings and makes appear separately below.
Community Evidence
Checking real impressions…
Before downloading
License
§
CC0 · Public domain
The author waives their rights to the extent permitted by law. Copying, modifying and reusing the work are permitted, including for commercial purposes.
✓ Share✓ Modify✓ Commercial use
Consult the full license ↗This summary facilitates reading and does not replace the legal conditions declared in the model sheet.
There are no comments yet. Verified ratings and makes appear separately below.