Información del modelo
Descripción
RC model waterproof boot vase mode
Purpose
This model is a waterproof boot designed to protect pushrods on an RC model.
Practical Uses
It is used to seal pushrod areas against water ingress. For a tighter seal at the exit part, the user can adjust the size by scaling the model or modifying the line width within the slicer. The author notes that applying silicone grease can result in quieter and smoother operation.
Included Parts
- Boot.stl
Printing and Assembly Guidance
To achieve waterproofing, the author recommends printing the model in vase mode. The material used for the provided example was Geeetech Black TPU 95A. For installation, the part can be fixed in place using superglue.
Texto original del autor en Printables
<p>To waterproof pushrods on Your RC model, print in vase mode.</p><p>You can adjust the size of the “exit” part by scaling or adjusting the line width in the slicer, may be a tight fit to seal properly.</p><p>I used silicone grease on mine to be a bit quieter and slide easier, works fine.</p><p>Printed from Geeetech Black TPU 95A, fixed in place with superglue.</p>
Preguntas y aportaciones