A waterproof boot designed for RC model pushrods. The author recommends printing in vase mode to achieve waterproofing. The size of the exit part can be adjusted by scaling or modifying the line width in the slicer to ensure a tight seal. The author used silicone grease for quieter and smoother operation and fixed the part in place with superglue. The author lists Geeetech Black TPU 95A as the filament used.
Original text by the author on Printables
<p>To waterproof pushrods on Your RC model, print in vase mode.</p><p>You can adjust the size of the “exit” part by scaling or adjusting the line width in the slicer, may be a tight fit to seal properly.</p><p>I used silicone grease on mine to be a bit quieter and slide easier, works fine.</p><p>Printed from Geeetech Black TPU 95A, fixed in place with superglue.</p>
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.
The publishing account has not yet confirmed any print settings. Material, supports, difficulty, temperatures and times remain as "Not verified" until verifiable data is available.
Conversation and organization
Save it with context.
Collections are used to organize projects; comments, to ask or provide information without converting it into an evaluation.
There are no comments yet. Verified ratings and makes appear separately below.
Community Evidence
Checking real impressions…
Before downloading
License
§
CC0 · Public domain
The author waives their rights to the extent permitted by law. Copying, modifying and reusing the work are permitted, including for commercial purposes.
✓ Share✓ Modify✓ Commercial use
Consult the full license ↗This summary facilitates reading and does not replace the legal conditions declared in the model sheet.
There are no comments yet. Verified ratings and makes appear separately below.