<p>My son's RC car lost one of the drive shafts, so I looked at the design of the one on the opposite side and designed this to fit the same. This is the revised version, I thickened the shaft portion and increased the infill to 80% to give it extra strength as the original part was made out of metal and the first model twisted from the torsional forces. This version has held up well, surviving a couple of runs at full speed with twists and turns and showing no signs of damage. I couldn't find any other models like this and the original parts are hard to find and expensive when you can.</p><p>Printed in PLA+.</p>