Model information
Description
An RC car body post cushion designed to support a polycarbonate body when mounted on posts, serving as an alternative to using body clips and foam. The design lacks a small curve at the top, which the author suggests can be achieved by applying heat to PLA or PETG prints.
The author printed these using Fiberlogy MattFlex 40D TPU with 4 walls and 100% infill. They also successfully tested them with PETG using 4 walls and 100% infill. The author notes that PLA+ should also work, but recommends TPU as the best material.
Original text by the author on Printables
<p>This is an RC Car body Post cushion that is usually used to rest the Polycarbonate Body once mounted on the Posts instead of only using the Body clips and a piece of foam. </p><p>It's a very simple design, Nothing Special and the dimension is almost exactly like the ones that are usually bought from the local Hobby shop or from the Internet. the only difference is that they Don't have that small curve at the Top but I think it is easily done if printed with PLA or PETG and using heat to make a permanent curve. I needed another Set and my local hobby shop didn't have any so I didn't want to wait for at least a week to get a set posted to me. </p><p>I printed Mine with Fiberlogy MattFlex 40D TPU</p><p>4 Walls</p><p>100% Infill</p><p>I also tried them with PETG with the same number of walls as above, including Infill, PLA+ should also work But I think TPU is the best material for it.</p><p> </p><p> </p><p> </p>
There are no comments yet. Verified ratings and makes appear separately below.