MESHOPIAModel sheet · for your workshop
RC & Robotics
RC 1/8 Subaru WRX front and rear LED lights
Authorship, licence & source
- Original author
- Tomi Pohjamo
- Publishing account
- Meshopia
- Licence
- CC0 · Public domain · Full terms
- Availability
- Free package hosted by MESHOPIA
- Listed contents
- 3 files · STL
- Declared source
- Printables
- Source link
- https://www.printables.com/model/1432286
Read the licence terms on the original listing. This sheet does not replace those terms or grant file access or additional rights.
Project documentation
- Assembly manual
- Not identified in the file list
- Bill of materials
- Not identified in the file list
Grouped by filename, without inspecting contents. Links lead to the public model listing; this sheet does not include the documents or grant access to paid downloads.
Before making: confirm additional parts, electronics, tools, scale and mounting points with the creator. A bill of materials does not establish that the assembly has been built or tested.
Print preparation
- Print status
- Not verified
Scale modelling & compatibility
- Project type
- Functional RC
- Scales
- 1:8
Scales and compatibility are as published. Rescaling can change tolerances, fit and hardware requirements.
Published description
RC 1/8 Subaru WRX Front and Rear LED Lights
Purpose
These components are designed to provide LED lighting for a Delta Plastik USA Subaru WRX 1/8 scale body. They are intended for use on 1/8 scale buggies, both nitro and electric.
Practical Uses
These parts are used to add scale lighting effects to RC rally vehicles, specifically for night rally scenarios.
Included Parts
The model includes files for:
- Hood LED components (4x)
- Front light components
- Rear light components
Required Components
To complete the lighting setup, the following LEDs are required:
- Rally night headlights: 4pcs 20mm 3W LED spotlights.
- Front lights: 2x 5mm super LED and 1x 3mm super LED.
- Rear lights: 2x 3mm super LED.
The author notes using an RC car lightset from AliExpress (approximately 10€).
Printing and Assembly Guidance
For printing, the author suggests using PLA impact, TPU, or PETG. Recommended print settings include 100% infill and a 0.2 layer height.
Attribution: RCMAN79
Declared changes from the original
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.