Información del modelo
Descripción
MatterHackers CR-10 Door Handle
Purpose
This model is designed to serve as a door handle for the MatterHackers CR-10 Enclosure, functioning to keep the door closed tightly without excessive pressure or large air gaps.
Practical Uses
It is intended for use on a CR-10 enclosure to manage door closure. The author notes that when using low infill and self-tapping type screws, the screws can be driven directly into the printed material (such as PLA).
Included Parts
The download includes a STEP file (MatterHackers_Enclosure_Handle.step) to allow for customization of the holes, and an STL file (MatterHackers_Enclosure_Handle_V2.stl).
Printing and Assembly Guidance
The author reports that the part prints in under an hour. For printing, a minimum of four top and bottom shells is recommended. The author used 5% infill for their version. Note that printing at high speeds may result in underextrusion. To customize the holes using the STEP file, separate the top from the bottom and export them as individual STL files.
Texto original del autor en Printables
<p>This does not need much in the way of infill (I used 5%), and it prints in under an hour.<br><br>The pictures I posted are of my prototype, and used screws I had laying around. With low infill and self-tapping type screws, you can go straight into the PLA (or whatever material you're using).</p><p>I have included the STEP file so that you can customize the holes to your needs. Then just separate the top from the bottom and export them to STL.<br><br>With the current setup, the door stays closed fairly tightly, without being under pressure, but also without leaving too much air gap.<br><br>I do recommend at least four top and bottom shells. I had two on the prototype and you can see a little bit of underextrusion (partially from the print being done at high speed).<br><br> </p>
Preguntas y aportaciones