Glue tube holder for UHU glue tubes (250g). The author reports that the holder provides a stable stand and can be glued to a surface (e.g., a table) if desired. The author printed this with 2 wall lines and 15% infill, stating this is completely sufficient. The design is intended to be printed without support structures. Print time and filament consumption are shown in the image.
<p>Nie mehr warten oder die Tube schütteln bis der Leim aus der Tube kommt! Der Leimtubenhalter gibt stabilen Stand und kann auf Wunsch auch auf eine Oberfläche (z.B. Tisch) geklebt werden. Ich habe ihn mit 2 Wandlinien und 15% Füllung gedruckt. Das ist völlig ausreichend. Druckzeit und Filamentverbrauch siehe Bild. Das Design ist so ausgelegt, dass der Druck keine Stützstrukturen benötigt.</p><p>Viel Spass damit :-)</p>
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.
The publishing account has not yet confirmed any print settings. Material, supports, difficulty, temperatures and times remain as "Not verified" until verifiable data is available.
Conversation and organization
Save it with context.
Collections are used to organize projects; comments, to ask or provide information without converting it into an evaluation.
There are no comments yet. Verified ratings and makes appear separately below.
Community Evidence
Checking real impressions…
Before downloading
License
§
CC0 · Public domain
The author waives their rights to the extent permitted by law. Copying, modifying and reusing the work are permitted, including for commercial purposes.
✓ Share✓ Modify✓ Commercial use
Consult the full license ↗This summary facilitates reading and does not replace the legal conditions declared in the model sheet.
There are no comments yet. Verified ratings and makes appear separately below.