Información del modelo
Descripción
This custom-designed motor and transmission mount is engineered specifically for the Injora 370 motor with an integrated transmission. Its primary purpose is to provide a secure, clean mounting solution that ensures proper alignment and stability for the motor/transmission assembly during operation.
Practical uses include DIY chassis builds, custom RC conversions, and RC crawler projects. While designed for use with WPL C14, C24, and C44 platforms, the author notes that fitment may vary based on specific drivetrain configurations and chassis modifications; therefore, test fitting is recommended prior to final installation.
Included Hardware:
To complete the installation, you will need 4 stock mounting bolts/screws for the chassis rails and 4 bolts/screws from the Injora transmission. The author states that no additional extra hardware is required.
Printing and Assembly Guidance:
- Recommended Materials: PLA+ or PETG (PETG is preferred for increased durability).
- Print Orientation: Flat on the print bed.
- Infill: 20–40% recommended for structural strength.
- Supports: Angle the part at approximately 30 degrees and utilize organic supports.
Texto original del autor en Printables
<p>This is a <strong>custom-designed motor and transmission mount</strong> made specifically for the <strong>Injora 370 motor with integrated transmission</strong>.</p><p>The mount was designed for RC crawler and custom RC projects where a secure, clean mounting solution is needed. It provides proper alignment and stability for the motor/transmission assembly and is suitable for DIY chassis builds or custom conversions.</p><p><strong>Printing Notes:</strong></p><ul><li><p>Recommended material: <strong>PLA+ or PETG</strong> (PETG preferred for durability)</p></li><li><p>Print orientation: flat on the bed</p></li><li><p>Infill: 20–40% recommended for strength</p></li><li><p>Supports: angle the part at about 30 degrees and add organic supports</p></li></ul><p><strong>Notes:</strong></p><ul><li><p>Hardware 4 stock mounting bolts/screws to the chassis rails and 4 bolts/screws from the injora transmission, no need for extras</p></li><li><p>Designed for use with <strong>WPL C14 / C24 / C44</strong> platforms. Fitment may vary depending on chassis mods and drivetrain configuration—test fitting is recommended before final installation.</p></li></ul><p>If you make improvements or adaptations, feel free to remix and share!</p><p></p><p></p><p>Extras- feel free to message about getting parts done or any questions. i am on my engineering journey so all feedback and suggestions would be greatly appreciated :)</p>
Preguntas y aportaciones