<p>This is a <strong>custom-designed motor and transmission mount</strong> made specifically for the <strong>Injora 370 motor with integrated transmission</strong>.</p><p>The mount was designed for RC crawler and custom RC projects where a secure, clean mounting solution is needed. It provides proper alignment and stability for the motor/transmission assembly and is suitable for DIY chassis builds or custom conversions.</p><p><strong>Printing Notes:</strong></p><ul><li><p>Recommended material: <strong>PLA+ or PETG</strong> (PETG preferred for durability)</p></li><li><p>Print orientation: flat on the bed</p></li><li><p>Infill: 20–40% recommended for strength</p></li><li><p>Supports: angle the part at about 30 degrees and add organic supports</p></li></ul><p><strong>Notes:</strong></p><ul><li><p>Hardware 4 stock mounting bolts/screws to the chassis rails and 4 bolts/screws from the injora transmission, no need for extras</p></li><li><p>Designed for use with <strong>WPL C14 / C24 / C44</strong> platforms. Fitment may vary depending on chassis mods and drivetrain configuration—test fitting is recommended before final installation.</p></li></ul><p>If you make improvements or adaptations, feel free to remix and share!</p><p></p><p></p><p>Extras-&nbsp; feel free to message about getting parts done or any questions.&nbsp; &nbsp;i am on my engineering journey so all feedback and suggestions would be greatly appreciated :)</p>