Explore an airless wheel design for an RC car using an open honeycomb tire structure and a separate rim. The actual STL geometry shows a ring of polygonal cells surrounding a recessed center, with block-style outer tread. The supplied installation photograph shows this style of wheel on an RC chassis; that chassis, its electronics and its other mechanical components are not included.

Three STL files are supplied: a tire labeled Airless Tire, a second tire labeled Airless Tire Round, and a rim labeled Rim OUT. Their English filenames distinguish the two tire variants and the outer rim component. Both tire variants and the rim retain their original geometry. The source inventory does not establish a verified vehicle scale or compatibility with a particular axle or drive interface.

The rim has a recessed center, reinforcing surfaces and a toothed outer profile. For the cover reference, one tire and the rim were combined in Blender at their original coordinates, without altering either mesh or adding a hub, fastener or axle. This supports an assembly visualization but does not verify physical tolerances or operation.

Inspect the tire cells, tread, rim interface and center opening in your slicer before printing. Choose material and settings for your intended flexibility and load. No physical fit, durability, speed or traction tests are documented by MESHOPIA. Fasteners, motor, axle and radio hardware are not supplied.

The current cover is an original AI-assisted MESHOPIA photorealistic illustration of the supplied model or its components in a hobby-workshop use or finishing scene. It illustrates a proposed finish and does not document a manufactured, printed, assembled or tested prototype. Consult the downloadable source files for the geometry and included components.