MESHOPIAFicha del modelo · para tu taller
Electronics
Generic DC Power Supply Wall Mount
Autoría, licencia y procedencia
- Autor original
- Zero Day
- Cuenta publicadora
- Meshopia
- Licencia
- CC0 · Dominio público · Texto completo
- Disponibilidad
- Paquete gratuito alojado en MESHOPIA
- Contenido anunciado
- 4 archivos · STL · STEP
- Fuente declarada
- Printables
- Enlace de procedencia
- https://www.printables.com/model/1281445
Consulta las condiciones de la licencia en la ficha original. Esta hoja no sustituye su texto ni concede acceso a archivos o derechos adicionales.
Documentación para tu proyecto
- Manual de montaje
- No identificado en el listado
- Lista de componentes
- No identificado en el listado
Agrupación por nombre de archivo, sin comprobar su contenido. Los enlaces llevan al listado público del modelo; esta hoja no incluye los documentos ni concede acceso a descargas de pago.
Antes de fabricar: confirma componentes adicionales, electrónica, herramientas, escala y puntos de montaje con el autor. Una lista de componentes no acredita que el conjunto haya sido montado o probado.
Preparación de impresión
- Estado de impresión
- No comprobado
Descripción publicada
Generic DC Power Supply Wall Mount
Purpose
This model is a case designed to enclose a generic 12V power supply unit (PSU) and mount it to a wall. It is intended to fit most standard standalone power supplies used in 3D printing, such as Mean Well models. The design features ventilation holes, though one side lacks holes to prevent dust collection inside the PSU. A specific hole is included to allow visibility of the status indicator light.
Practical Uses
This case is used for organizing and securing power supplies on a sturdy surface. It allows for easy access to connectors while keeping the unit enclosed. The design includes a cap to close off the open side of the case.
Included Parts
- Power Supply Mount - Case
- Power Supply Mount - Cap
Printing and Assembly Guidance
For printing the case, use tree supports and an infill of ≥ 15% with ≥ 2 walls. When printing the cap, it is recommended to print at under 100% scale depending on your printer's accuracy and filament. Users should consider the thermal properties of their chosen filament against the heat generated by the PSU.
To assemble, disconnect the power, install the case on a surface using screws (5mm diameter holes), and slide the PSU in so connectors are accessible and ventilation patterns match. If using the cap, snap it into place via friction fit. To remove the PSU, disconnect power and push the unit from the covered side; if the cap is installed, it should pop off with the force of the PSU.
Cambios declarados respecto al original
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.