Mount a suitable small FPV camera and transmitter together on this compact bracket. The supplied photograph shows an FPV installation on an RC aircraft. Inspection of the actual STL reveals two raised side walls with camera mounting holes, an open central frame, upright rear slots and four rounded mounting feet with holes.

One STL is included, renamed 01-fpv-camera-transmitter-bracket.stl. The camera, transmitter, antenna, aircraft, wires and fixing hardware are not included. The original mesh is preserved. Although the filename contains "3mf", the supplied file is an STL.

The source identifies a 19 x 19 camera, TS5823 and "No Supports". These are supplied design labels; device compatibility and support-free printing have not been independently tested by MESHOPIA. Compare the actual hole spacing, openings and clearances with your hardware and inspect the part in your slicer. No vehicle scale or tested print profile is supplied.

The new cover was created locally in ComfyUI from a render of the actual STL. It shows the bracket alone in a forest-green finish on a pale textured studio surface; the real mounting holes, rear slots and open frame were checked against the mesh.