Create a wheel-rim option for a suitable 1:10 RC drift car with this five-spoke design. Inspection of the supplied STL shows five broad spokes surrounding the central opening, a deep cylindrical barrel and raised circumferential lips. The folder identifies Tamiya and 1:10; these are supplied compatibility and scale labels.

Two original files are included: 01-five-spoke-drift-rim.3mf and 02-five-spoke-drift-rim.stl. They provide the source project and mesh forms of the rim design, rather than a complete set of tires or a vehicle. Project contents and geometry are preserved. Tires, wheel nuts, axles and other hardware are not included.

Check axle interface, offset, rim diameter and tire fit against your intended chassis. Compatibility with particular Tamiya models and physical fit have not been independently tested by MESHOPIA. Inspect the files in your slicer and choose material and orientation for your intended use. No tested print profile is supplied.

The new studio cover uses the actual STL geometry in a bronze finish, from a new angle on a pale stone surface. It preserves all five spokes and the original barrel.