MESHOPIAModel sheet · for your workshop
Tools
First layer calibration matrix by zones
Authorship, licence & source
- Original author
- Marc Neuhaus
- Publishing account
- Meshopia
- Licence
- CC0 · Public domain · Full terms
- Availability
- Free package hosted by MESHOPIA
- Listed contents
- 2 files · PDF · 3MF
- Declared source
- Printables
Read the licence terms on the original listing. This sheet does not replace those terms or grant file access or additional rights.
Project documentation
- Assembly manual
- Not identified in the file list
- Bill of materials
- Not identified in the file list
Grouped by filename, without inspecting contents. Links lead to the public model listing; this sheet does not include the documents or grant access to paid downloads.
Before making: confirm additional parts, electronics, tools, scale and mounting points with the creator. A bill of materials does not establish that the assembly has been built or tested.
Print preparation
- Print status
- Settings declared by the publisher
- Technology
- FDM
- Material
- PLA, PETG
- Supports
- No
- Difficulty
- Intermediate
- Layer height
- 0.20 mm
- Nozzle
- 0.40 mm
- Infill
- 15 %
Published description
Low-thickness technical part designed to quickly and comparably check how the first layer is deposited in different areas of the print bed. The matrix allows for observing variations in squish, line continuity, and adhesion without consuming much material, making it useful after leveling the bed, adjusting the Z offset, changing the print surface, or modifying the slicer profile. Each sample must be interpreted as a visual reference: separated lines usually indicate excessive height; a very squashed, rough, or translucent surface may indicate a nozzle that is too close. The model does not automatically correct mechanical problems, dirt, bed deformation, or poorly calibrated flow.
Manufacturing & assembly notes
General recommendations not tested by Meshopia. Check orientation, bridges, and overhangs in the slicer before printing; activate supports only where necessary. As a prudent starting point, use a 0.40 mm nozzle, 0.20 mm layer height, 3 perimeters, and 15–20% infill. Adjust temperatures, adhesion, cooling, and speed to the actual profile of PLA, PETG, and the printer. The recommendations are a starting point and must be verified in the slicer. No medical, structural, food, or safety properties are claimed without specific documentation.
Declared changes from the original
Imported CC0 model; editorial description and realistic visualization prepared for Meshopia.