Model information
Description
Purpose
This spacer allows a CR Touch to be used with a V3 KE/K1 hotend when installed in a V3 SE printer. The design is based on the Volcano bracket by T3KPrinter.
Practical Uses
It serves as an adapter to accommodate the specific geometry of the KE/K1 hotend within the V3 SE setup.
Included Parts
V3SE-CRTouchSpacer.stl
Assembly Guidance
Installation requires two longer M3 screws because the original screws will not reach through the spacer. The author used 12mm screws, though 10mm screws may also work.
Original text by the author on Printables
<p>This is a CR Touch Spacer for the V3 KE/K1 Hotend installed in the V3 SE.</p><p>I based this spacer in the Volcano bracket by T3KPrinter as I did'nt think printing the whole bracket was necessary.</p><p>You will need two longer M3 screws as the originals won't reach through the spacer. I used 12mm but as you can see in the image, they are longer than necessary. 10mm would probably be fine.</p>
Questions and contributions