Model information
Description
A drift ring designed for the MJX Hypergo 1430x 1:14 scale stock tires, intended to convert the RC car for drifting. The ring is designed for a snug fit over the default rubber tire to prevent slipping.
Assembly Instructions:
- One side of the ring features an inside edge/lip; this edge must face the inside of the car.
- Remove the wheel/tire from the car, slide the ring on with the correct orientation, and remount the wheel.
Print Settings:
- Material: The author recommends PETG for impact resistance and durability on hard surfaces.
- Infill: 100% (solid layers are required for structural integrity and longevity).
Files: mjx_hyper_go_drift_ring_1_14.stl
Original text by the author on Printables
<p>This is a drift ring designed specifically for the <strong>MJX Hypergo 1430x</strong> 1:14 scale stock tires. It allows you to easily convert your RC car for drifting and gets you cheap replacements.</p><h3>Installation & Fit</h3><ul><li><p><strong>Snug Fit:</strong> This ring is designed to fit tightly over the default rubber tire to prevent slipping.</p></li><li><p><strong>Orientation Matters:</strong> One side of the drift ring features an inside edge/lip. This edge must face the <strong>inside</strong> of the car.</p></li><li><p><strong>Assembly:</strong> You will need to remove the wheel/tire from the car first, slide the ring on with the correct orientation, and then remount the wheel.</p></li></ul><h3>Print Settings</h3><ul><li><p><strong>Material:</strong> PETG (highly recommended for impact resistance and durability on hard surfaces)</p></li><li><p><strong>Infill:</strong> 100% (solid layers provide the structural integrity and longevity needed as the ring wears down)</p></li></ul><p></p>
There are no comments yet. Verified ratings and makes appear separately below.