MESHOPIAModel sheet · for your workshop
RC & Mechanics
H9 model airplane starter base
Authorship, licence & source
- Original author
- Arsan
- Publishing account
- Meshopia
- Licence
- CC0 · Public domain · Full terms
- Availability
- Free package hosted by MESHOPIA
- Listed contents
- 2 files · STL
- Declared source
- Printables
Read the licence terms on the original listing. This sheet does not replace those terms or grant file access or additional rights.
Project documentation
- Assembly manual
- Not identified in the file list
- Bill of materials
- Not identified in the file list
Grouped by filename, without inspecting contents. Links lead to the public model listing; this sheet does not include the documents or grant access to paid downloads.
Before making: confirm additional parts, electronics, tools, scale and mounting points with the creator. A bill of materials does not establish that the assembly has been built or tested.
Print preparation
- Print status
- Not verified
Published description
Base for placing an H9 starter next to its battery. The preserved documentation mentions a three-cell 2200 mAh LiPo battery in the summary, but mentions two cells in the description. Neither of these electrical configurations is confirmed here: the allowable voltage must be obtained from the actual starter and its documentation.
Preparation, compatibility, and printing
Measure the starter housing and the slot intended for the battery. The base is a mechanical part; it does not adapt voltages or provide electrical protection for the assembly. Check that the fastening does not press against the battery and leaves the cables free. The source does not specify a print profile; first prepare a dimensional test of the housings.
Manufacturing & assembly notes
Measure the starter housing and the slot intended for the battery. The base is a mechanical part; it does not adapt voltages or provide electrical safety for the assembly. Check that the fastening does not press against the battery and leaves the cables free. The source does not specify a print profile; first prepare a dimensional test of the housings.
Declared changes from the original
Imported CC0 model with an automated editorial listing; the generated photographic cover is pending.