MESHOPIAModel sheet · for your workshop
RC & Robotics
AVEX-2 1120mm - 3D Printed RC Airplane
Authorship, licence & source
- Original author
- Spike141
- Publishing account
- Meshopia
- Licence
- CC0 · Public domain · Full terms
- Availability
- Free package hosted by MESHOPIA
- Listed contents
- 20 files · 3MF · STEP
- Declared source
- Printables
- Source link
- https://www.printables.com/model/1822340
Read the licence terms on the original listing. This sheet does not replace those terms or grant file access or additional rights.
Project documentation
- Assembly manual
- Not identified in the file list
- Bill of materials
- Not identified in the file list
Grouped by filename, without inspecting contents. Links lead to the public model listing; this sheet does not include the documents or grant access to paid downloads.
Before making: confirm additional parts, electronics, tools, scale and mounting points with the creator. A bill of materials does not establish that the assembly has been built or tested.
Print preparation
- Print status
- Not verified
Scale modelling & compatibility
- Vehicle family
- Aircraft, Helicopters & Drones
- Project type
- Functional RC
Scales and compatibility are as published. Rescaling can change tolerances, fit and hardware requirements.
Published description
AVEX-2 1120mm - 3D Printed RC Airplane
Purpose
This model is a 3D printed remote-controlled airplane designed with a NACA 2410 airfoil profile. It is intended to achieve a target All-Up Weight (AUW) of approximately 1200g (+100g).
Practical Uses
This model is designed for RC flight using a single motor configuration. It is compatible with 2807 to 2812 brushless motors.
Included Parts and Hardware
The model features a wingspan of 1120 mm, a length of 680 mm, and a wing area of 21.56 dm². Required hardware and reinforcement include:
- 1x Main Wing Spar (6mm x 900mm rod)
- 1x Secondary Wing Spar (6mm x 300mm rod or BBQ skewer stick)
- 2x Elevon Control Rods (3mm x 300mm rods or BBQ skewer sticks)
- 2x 9g Micro servos
- Brushless motor (2807 to 2812 size)
Printing and Assembly Guidance
The author recommends using PETG filament. The estimated print weight is between 600g and 700g. Recommended print settings are:
- Layer Height: 0.28 mm
- Wall Loops: 1
- Top Shell Layers: 3
- Bottom Shell Layers: 2
- Sparse Infill Density: 3–4%
- Sparse Infill Pattern: Cubic
Declared changes from the original
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.