A demonstration of arc overhangs where a script turns overhang perimeters into arc overhangs. The author provides a generic PETG profile with 0.2LH and 0.6N settings. The author recommends setting the bridge fan speed to 100% for good cooling for arcs. The author notes that the script prints quite slowly by default and that there is room for improvement in the settings. The author suggests that if set up with smaller extrusions/nozzles, it could allow smaller arcs that would fill in and follow the perimeter closer in tight corners. The author recommends running PRUSA SLICER Gcode through this script: https://github.com/nicolai-wachenschwan/arc-overhang-prusaslicer-integration.