Información del modelo
Descripción
Purpose
This 2" (51mm) 3-blade spinner is designed for the 3dLabPrint 48" Edge 540. It provides propeller access when mounted and features a centering hub fit for the Eflite EFL01893 3 Blade 11x6 Propeller.
Practical Uses
The design includes a keyed tip that fits into the base and internal lip tabs intended to prevent spreading during tightening or high RPM operation.
Included Parts
- Spinner_Base.stl
- Spinner_Tip.stl
Printing and Assembly Guidance
The author recommends using a 0.16mm layer height and 100% infill. Organic supports are required. Assembly requires M3 heatset inserts and M3x20mm screws.
ON-DEMAND INSPECTION COPY
An additional source-derived STL simplifies dense triangles for interactive inspection. Source coordinate units are preserved. Original downloads remain unchanged; use them for fine details and fabrication checks.
Texto original del autor en Printables
<p>Needed a better more true spinning spinner for my 3dLabPrint 48" Edge 540.</p><p>This one has prop access when mounted. </p><p>Snug, centering hub fit for Eflite EFL01893 3 Blade 11x6 Propeller.</p><p>Uses M3 Heatset inserts with M3x20mm screws.</p><p>The tip keys into the base and there are tabs on the inside lip to keep it from spreading when tightened and during high RPM.</p><p>Made this from Polymaker PLA Pro</p><p>0.16mm Layer Height</p><p>100% Infill</p><p>It is very balanced right off the printer. Turns very true, and survived a NASTY wreck lol!</p><p>Requires Organic supports (See Image).</p><p> </p><p>Hope this helps someone out of a jam! </p><p> </p><p> </p><p> </p><p> </p>
Preguntas y aportaciones