QIDI X-Max 3 X-Plus 3 CR Touch Bracket
A mounting bracket for the CR Touch probe. The author notes that the CR Touch components must be removed from the cover to fit them into this bracket. The author reports using a 13/32 drill bit by hand to bore out the hole slightly and had to remove a bit of material for the board to fit. The author suggests using a very small drop of epoxy on the board and probe case to hold them in place, ensuring the pin is aligned with the U of the sensor. The author reports using glass filled nylon, noting it prints a bit rough, and suggests PETG might print more accurately. Regarding wiring, the author states the CR Touch is not wired like a BL Touch. On the extruder board, the pins are labeled left to right as follows: - 2 pin plug: Red (ground), Blue (signal) - 3 pin plug: Black (5V), White (Ground), Yellow (Pin up/down control) The author notes that pins can be removed from the plug housings on the cables to re-use old probe plugs with the new CR Touch cable, but warns they can be crushed. Klipper configuration instructions provided by the author: Edit printer.cfg in Klipper. Comment out (leading # on each line) [Probe] and everything else in the probe section, then paste the following: [bltouch] sensor_pin: ^MKS_THR:gpio21 control_pin: MKS_THR:gpio11 x_offset: 28 y_offset: 4.4 z_offset: 0.0 speed: 5 samples: 2 samples_result: average sample_retract_dist: 3.0 samples_tolerance: 0.08
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar