RC & MecánicaGratis
Wheel Offset Gauge for RC Drift
A tool for comparing wheel offsets for a 1/10 RC drift car. To operate, fully insert the tool into the 12mm wheel hex and press the slider against the back edge of the wheel; the line that the top edge of the gauge lines up with indicates the offset. The slider is captured within the tool. Measurements range from 0 to 10mm of offset. Printing notes: Print the gauge on its top face, the end without the peg. To capture the slider, pause the print somewhere between 5mm and 20mm z-height, install the slider at this time, and then resume printing. Adaptive/variable layer heights will make the numbers more legible.
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar