Meshopia · EnglishEnglish
MESHOPIAScale modelling & RC

1 modelo etiquetado

#matterhackers cr-10

Descubre modelos 3D etiquetados como matterhackers cr-10 y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →
Vista de MatterHackers CR-10 Door Handle

MatterHackers CR-10 Door Handle

A door handle for the MatterHackers CR-10 Enclosure. The author reports using 5% infill and that it prints in under an hour. The author recommends at least four top and bottom shells. The author notes that with low infill and self-tapping type screws, screws can go straight into the PLA (or whatever material is being used). The author reports that with the current setup, the door stays closed fairly tightly without being under pressure, but without leaving too much air gap. The author notes that their prototype showed a little bit of underextrusion, partially due to printing at high speed. A STEP file is included to allow customization of the holes.

Technology
Sin probar
material
—
Difficulty
Sin especificar