Low Profile Screw-on 1/10 RC hex covers
A set of three different nut covers designed for 1/10 scale RC vehicles to prevent losing nuts on carpet tracks. The author recommends printing these in TPU (specifically mentioning SainSmart) and notes that while the prints are not pre-threaded, the TPU will self-tap onto the axle threads. Included models: - long pro - hex cover: Designed for 2WD rear axles that extend several millimeters past the nut. These are intended to screw onto the axle threads over a low profile nut. The author states they are strong enough to hold the car by. - medium pro - hex cover: Designed for axles with 1-2mm poking out (e.g., B84 rear on 7mm hex or B7 front). Designed for low profile nuts; they provide a slight screw-on effect. - low pro - hex cover: A flat cap that does not screw on. Designed for scenarios where the nut protrudes but the axle is buried (e.g., wheeler front). These are slightly smaller than the nut head to allow for TPU stretch. Author's Note: To improve retention, the author suggests placing the covers 'flats to points' on the nut so they do not line up with the nut's flat sides.
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar