MESHOPIAScale modelling & RC3 tagged models · Page 1 of 1
This model is a mount designed for the Traxxas Slash 4x4. It is intended to fit the HCG chassis and the Copperhead ESC. Practical uses include mounting a Copperhead ESC within an HCG chassis on a Traxxas Slash 4x4 platform. Included files: traxasslashhcgcopperheadescmount.stl
Nacelle for rc plane Purpose This model is a nacelle designed to attach Flite Test motors to the exterior of a scratch-built airplane. Practical Uses The design provides internal storage space for an Electronic Speed Controller (ESC). It features an integrated air scoop specifically designed to provide cooling for the stored ESC. The rear of the nacelle includes holes sized to accommodate a hex key, which facilitates the motor mounting process. Included Parts - Nacelle prototype.stl Printing and Assembly Guidance The mounting holes provided in the rear of the design are pilot holes only; the user must drill them out to complete the motor mounting setup.
ESC Mount for Losi XXX-CR Purpose This model is a small mount designed to hold a brushless ESC within the Losi XXX-CR chassis. It is specifically designed to manage space constraints, allowing the components to fit under the XXX-CR body where room is limited. Practical Uses Once attached to the chassis, the ESC is secured to the mount using double-sided tape. This provides a dedicated location for the electronic speed controller in a tight compartment. Included Parts - ESC mount (available in .stp, .3mf, and .stl formats) Assembly Guidance The mount utilizes existing unused holes located on each side of the battery bay. To install, the holes in the chassis must be tapped using a #4-40 hand tap, and the bracket is then attached with suitable #4-40 screws. The source notes that M3 taps and fasteners may also work for this application.