Vehicle Cradle for a DJI RC2 Controller - Single STL
Position a suitable DJI RC2 controller using this printable vehicle cradle. The supplied photograph shows a controller supported inside a vehicle. Inspection of the actual STL reveals a broad lower ledge, tall curved side retainers with rectangular openings, and a raised rear mounting section. One original STL is included, renamed 01-dji-rc2-vehicle-cradle.stl. The controller, vehicle dashboard, fastening hardware and cables are not included. The original mesh is preserved and no vehicle scale is associated with this controller accessory. DJI RC2 is the supplied source identification; fit, attachment method and stability in a vehicle have not been physically verified by MESHOPIA. Compare the holder openings and contact surfaces with your controller and planned mounting location before printing. Inspect orientation and supports in your slicer. No tested print profile is supplied. The new cover renders the actual holder alone in a blue finish on a pale stone studio surface from a fresh camera angle.
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar