Meshopia · EnglishEnglish
MESHOPIA

4 modelos etiquetados

#3d printers

Descubre modelos 3D etiquetados como 3d printers y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →
Vista de Matriz de calibración de primera capa por zonas

First layer calibration matrix by zones

Low-thickness technical part designed to quickly and comparably check how the first layer is deposited in different areas of the print bed. The matrix allows for observing variations in squish, line continuity, and adhesion without consuming much material, making it useful after leveling the bed, adjusting the Z offset, changing the print surface, or modifying the slicer profile. Each sample must be interpreted as a visual reference: separated lines usually indicate excessive height; a very squashed, rough, or translucent surface may indicate a nozzle that is too close. The model does not automatically correct mechanical problems, dirt, bed deformation, or poorly calibrated flow.

Technology
FDM
material
PLA, PETG
Difficulty
Intermedia
Vista de Proyecto de avión de radiocontrol

Radio-controlled airplane project

A set of files identified by its author as an RC airplane. The original description only contains the indication "RC", so it does not document the assembly, electronics, functional dimensions, center of gravity, or a flight profile. The download must not be presented as a ready-to-assemble or ready-to-fly airplane. Preparation, compatibility, and printing Review the parts and request or locate the specific project documentation before selecting components or printing a complete set. The available geometry can be studied in CAD, but it does not allow for the deduction of a safe flight configuration on its own. This sheet remains pending verifiable instructions and compatibilities; generic printing values are not added to make the project appear complete. The download contains three STLs: RC AERO AIRPLANE 1 .stl, RC AERO AIRPLANE 2.stl, and RC AERO AIRPLANE 3.stl. The numerical names do not specify the function of each part. The source review from September 24, 2026, confirms that no assembly instructions have been added.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Bastidor FPV para tubos de carbono de 8 mm

FPV frame for 8 mm carbon tubes

Components of an FPV drone frame with 8 mm carbon fiber tube arms and motor mounts. The design allows for varying the arm length, but that possibility does not establish a validated flight configuration. The download does not include tubes, motors, propellers, or electronics. Preparation, compatibility, and printing The author indicates orienting the motor mounts with the screw holes facing the sides and the base plates facing up. Check this reference against each file and review the necessary supports in the slicer. Verify the motor pattern, the tube retention, and the clearances. No material or full profile is specified; the assembly requires checking rigidity and fastening before use.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Plataforma plegable de aterrizaje para drones de 30 × 30 cm

30 × 30 cm foldable landing platform for drones

30 × 30 cm foldable platform for small drones, with a landing signal and DJI logo in the original design. The author describes an assembly using 16 magnets. It is a modeling support surface, not a guidance system or a guarantee of automatic landing. Preparation, compatibility, and printing The source cites magnets 10 mm wide and 3.5 mm deep, while its purchase reference points to 10 × 4 mm. Measure the housings before buying or inserting the magnets and check the polarity of each joint. Check the different pieces and their folding. Material, layer, and infill are not specified; verify that the assembled platform remains flat and stable.

Technology
Sin probar
material
—
Difficulty
Sin especificar